MULTIQUIP GLOBUG Series Operation And Parts Manual page 22

CAUTION
DO NOT replace fi lter immediately, allow
a suffi cient amount of time for the lamp
assembly to cool down before changing
fi lter
FILTER REPLACEMENT
1. Remove the balloon as described in the "Removing
the Lamp/Balloon" section.
2. Disconnect the lamp power cable (Figure 5).
3. Rotate the balloon/lamp base assembly so that the
fi lter is facing upwards. See Figure 26.
BALLOON/LAMP
Balloon/Lamp Placement
Figure 26.
4. Turn the three locking tabs (Figure 27) inward to
release the plate. Remove plate and fi lter.
PLATE
FILTER
LOCKING
Figure 27.
GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09) — PAGE 23
TURN
OUTWARD
TO RELEASE
TAB
Filter Removal
5. Install a new fi lter over the brace as shown in Figure
28. Be sure to align the cut of the fi lter over the brace.
BRACE
Figure 28.
CAUTION
When placing the fi lter element, always align the cut
of the fi lter on top of the brace. This will keep the fi lter
from being dislodged and getting damaged.
6. Turn the three retaining tabs (Figure 29) outward so
that they touch the lamp base.
PLATE
FILTER
Figure 29.
MAINTENANCE
FILTER
CUT
Filter Placement
TURN
INWARD
TO LOCK
LOCKING
TAB
Filter/Plate Install