MULTIQUIP GLOBUG Series Operation And Parts Manual page 21

3. Push down and hold the lamp holder (spring loaded)
away from the lamp (Figure 21). Unscrew the lamp
(turn counterclockwise) from the lamp socket.
LAMP
HOLDER
PUSH
DOWN
Figure 21. Removing the Lamp
INSTALLING A NEW LAMP
1. When installing a new lamp (Figure 22) use only
MQ recommended type lamp. See parts section of
this manual. Failure to use correct type lamp could
adversely affect lighting capability and may cause
damage to the equipment.
2. Push down and hold the lamp holder (spring loaded)
away from the lamp. Screw the lamp (turn clockwise)
into the lamp socket. Gently place the lamp holder
fi rmly over the top of the lamp. This will prevent the
lamp from touching the lamp guard or pipe frame.
LAMP
HOLDER
(SPRING-LOADED)
Figure 22.
R E - I N S TA L L I N G T H E L A M P / B A L L O O N
ASSEMBLY
1. Reinstall the lamp guard (Figure 23). Be careful not to
install the lamp guard in the wrong direction.
PAGE 22 — GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09)
LAMP
SOCKET
TO REMOVE LAMP
TURN COUNTER-
CLOCKWISE
LAMP
SOCKET
TO INSTALL LAMP
TURN CLOCKWISE
PLACE
LAMP HOLDER
FIRMLY ONTO
LAMP TOP
Installing the Lamp
PIPE FRAME
Figure 23. Installing the Lamp Guard
2. Zip up the zipper at the bottom (Figure 19) of the
balloon and pull down the balloon envelope to cover
the lamp
3. Place the lamp/balloon assembly back onto the mast.
4. Tighten the T-Handle Bolt Lock to secure the lamp to
the mast.
5. Reinstall the protective cover over the balloon/lamp
assembly. Be sure to fold the velcro tabs.
6. Reconnect the power cables.
REPLACING THE BALLOON
1. Follow the procedures as outlined in the "Removing
the Balloon Lamp" assembly section.
2. Unzip the zipper at the bottom and top of the balloon.
Slide the balloon over the top of the lamp guard as
shown in Figure 24.
LAMP
GUARD
Removing the Balloon
Figure 24.
3. Slide the new balloon over the top of the lamp guard
as shown in Figure 25. Zip up the zipper at the bottom
and top of the balloon.
LAMP
GUARD
Removing the Balloon
Figure 25.
MAINTENANCE
BALLOON
SNAP LAMP
GUARD INTO
PIPE FRAME
BALLOON
BALLOON