MULTIQUIP GLOBUG Series Operation And Parts Manual page 14

Figure 5 shows the location of the components for the
GloBug lighting system. The function of each component
is described below:
1. Lamp Guard — This guard (cage) protects the lamp
from being hit by objects.
2. Lamp — 1000 watt metal-halide type lamp. Replace
only with MQ recommended type lamp. Always allow
a suffi cient amount of time for the lamp to cool down
before changing.
3. Fan Motor (Blower)
responsible for infl ating the balloon. It will supply a
pressure of 31.26 psi /215.6 kPA. Please note that the
balloon will begin to infl ate as soon as power is applied
to the lighting system.
4. Balloon Cover/Carrying Case
protective cover acts like a carrying case. The complete
lamp assembly is enclosed within the cover-carrying
case. Allow a suffi cient amount of time for the lamp
to cool down before covering balloon. The possibility
exists of the balloon getting burned.
5. Lamp Assembly Connector
cable. Provides AC power to lamp assembly.
GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09) — PAGE 15
— This electric motor is
— When zipped, this
— Quick-disconnect
6. T-Handle Bolt Lock
the lamp/balloon securely in place.
7. Balloon — This balloon is made of heat-resistant
nylon, with a diameter of 47 inches (1200 mm).
8. Offset Pole — Supports lamp assembly when attached
to the main mast. Included with the offset pole is a
17/19 mm wrench.
9. Lamp Power Cable (Output)
between the ballast receptacle and the lamp assembly
connector.
10. Pole Clamps — Attach these clamps (2) to the
main pole and external support pole. Always tighten
both clamps securely to prevent slippage of the light
assembly.
11. Main Pole — Used in conjunction with the offset pole
to support the lamp assembly.
12. Ballast — Power source for lamp. Input power
requirements are 120 VAC, 60 Hz @9.5 amps.
13. Ballast AC Power Cable (Input)
to a 120 VAC, 60 Hz power source.
COMPONENTS
— Always tighten this lock to hold
— Connect this cable
— Connect this cable