Advertisement
Maintenance
Our wheels are designed with high-grade, sealed roller bearings that
are greased from the factory and will never require oil or any other
attention. No parts of our wheels require oil or grease of any kind.
IIf you notice your achievable tension decreasing over time, the Kevlar
tension belt may need to be cleaned of aluminum oxide buildup.
Inspect the area of the belt that contacts the aluminum drum. If there
is a large buildup of dark powder, you can freshen it by gently brushing
the belt with your thumbnail to remove most of the alumina. The
contact area of the Kevlar may show some "seasoning" in the form of
being a little fuzzy. This is to be expected and should not change the
tension profile. The provided belt material is 1.5 mm Kevlar (yellow).
You may experiment with other Kevlar braids from 1.0 to 3 mm for a
softer or firmer tension profile. You are welcome to try other materials
like cotton, nylon, or silk.
To keep your Martin clean we highly recommend spinning with clean,
well prepped fiber. This will help minimize the debris that will end up
in your Martin's box. To clean your e-spinner, please use a lint-free
cloth. If needed, dampen the cloth lightly with water only. Please
do not use detergents or cleaners. Canned air is recommended for
keeping the Martin's box clean of fiber and yarn debris, but be certain
to keep the can upright while spraying to avoid damaging the surface.
If you live in a high-humidity area, you may notice some slight
tarnishing on the maiden bearing. This can be cleaned with a jewelry
polishing cloth.
Please inspect your rubber o-rings for any cracks, as dry rot can
happen in extremely dry climates. They can be protected with any oil
and are easily replaceable with the spares provided in your kit.
If you need any assistance with your wheel, please do not hesitate to
reach out to support@daedalusspinningwheels.com.
23
Advertisement
