Advertisement
Changing the Bobbin
When it's time to change your bobbin, simply slip off the tension belt
and the drive belt, then lift the flyer assembly from its cradles, remove
the rear bearing and place it in the rear cup so as not to lose it. Adjust
guides if needed, and remove the existing bobbin. Place a new bobbin
on the axle and readjust guides. With the new bobbin on the flyer
shaft, replace the rear bearing and reseat the flyer assembly back onto
the maiden and rear cups, making sure the small rear bearing goes
back onto the magnet on the rear cup. Replace the tension belt and
drive band, and you are ready to spin again!
Flyer
O-ring
20
Rear Bearing
Advertisement
