Selecting The Connected Usb Source; Disconnecting A Usb Device Or Camera From The Projector - Epson V11H389020 User Manual

2. Connect the USB cable (or USB flash drive or USB memory card reader) into the projector's USB
TypeA port shown below.
1 USB TypeA port
Note: Do not connect a USB hub or a USB cable longer than 10 feet (3 m), or the device may not
operate correctly.
3. Connect the other end of the cable (if applicable) to your device.
Parent topic:
Related topics
Projecting a Slide Show

Selecting the Connected USB Source

You can switch the projector's display to the source you connected to a USB Type A port.
1. Make sure the connected USB source is turned on, if necessary.
2. Press the USB button on the remote control.
3. Press the button again to cycle through other USB sources, if available.
Parent topic:

Disconnecting a USB Device or Camera From the Projector

When you finish presenting with a connected USB device or camera, you must prepare to disconnect the
device from the projector.
1. Select Exit from any software running your slide show or presentation from the device.
2. Disconnect the USB device or camera from the projector.
Connecting to External USB Devices
Connecting to External USB Devices
37