Advertisement
Available languages
Available languages
Existing Construction – accessible only from below
D11
D12
EXISTING FAN
F
Remove an existing fan and check to make sure the open-
Move the housing into position above the ceiling
ing is large enough to accommodate the new motor hous-
ing (9"x 9.75").
D13
D14
Route wires through the strain relief. For supply connection,
Attach existing ducting to duct connector. Tape joints.
use wires suitable for at least 90º C (194º F).
If ducting does not fit securely,
an adapter may need to be purchased.
D15
F
Screw pre-loaded screws into joist or framing.
41952-01 3/13/2006
15
05-HF-008-Eng_3.13.06.indd 15
3/13/06 12:09:04 PM
Advertisement
