Beko CWB 6666 X User Manual page 8

2 Installing your appliance
Assembly and electrical connections must
•
be carried out by specialized personnel.
Wear protective gloves before proceeding
•
with the installation.
Electric Connection:
The appliance has been manufactured as a
•
class II, therefore no earth cable is necessary.
The plug must be easily accessible after the
installation of the appliance. If the appliance is
equipped with power cord without plug, a suit-
ably dimensioned omnipolar switch with 3 mm
minimum opening between contacts must be
fitted between the appliance and the electricity
supply in compliance with the load and current
regulations.
The connection to the mains is carried out as
•
follows:
BROWN = L line
BLUE = N neutral.
The minimum distance between the support
•
surfaces of the cooking pots on the cooker top
and the lowest part of the cooker hood must be
at least 65 cm. If a connection tube composed
of two parts is used, the upper part must be
placed outside the lower part.
Do not connect the cooker hood exhaust to the
same conductor used to circulate hot air or for
evacuating fumes from other appliances gener-
ated by other than an electrical source. Before
proceeding with the assembly operations, re-
move the anti-grease filter(s) (Fig.7) so that the
unit is easier to handle.
In the case of assembly of the appliance in the
•
suction version prepare the hole for evacuation
of the air.
8 / 30 EN
We recommend the use of an air exhaust tube
•
which has the same diameter as the air exhaust
outlet hole. If a pipe with a smaller diameter
is used, the efficiency of the product may be
reduced and its operation may become noisier.
Please note:
If your version of the appliance has decorative
glass before installing the hood, carry out the fol-
lowing steps as shown in figure 4:
1. Remove both the cooker hood body B and the
glass panel A from the packaging and place
them horizontally on a secure surface.
2. Take the glass panel A and position it above the
cooker hood body B.
3. Fix the glass panel securely to the cooker hood
body using the 4 sleeves C and 4 screws D as
indicated.
Fixing to the wall:
Drill the holes A respecting the distances indi-
cated (Fig.2). Fix the appliance to the wall and
align it in horizontal position to the wall units.
When the appliance has been adjusted, definitely
fix the hood using the screws A (Fig.5). For the
various installations use screws and screw an-
chors suited to the type of wall (e.g. reinforced
concrete, plasterboard, etc.). If the screws and
screw anchors are provided with the product,
check that they are suitable for the type of wall on
which the hood is to be fixed.
Fixing the decorative telescopic
flue:
Caution! If your appliance model
A
features the lower connector with a
tab, before fixing it in place bend the
tab inwards using a pair of pliers, as
illustrated in figure 5, step1.
Cooker Hood / User Manual