Table of Contents
Advertisement
18
USING MAGIC REMOTE CONTROL
The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully to
use the Screen correctly.
Installing Batteries
•
Press the top of the battery cover, slide it back, and lift the cover as shown below.
•
To replace batteries, open the battery cover, replace alkaline batteries (1.5 V, AAA)
matching
and
ends to the label inside the compartment, and close the battery
cover. Be sure to point the remote control at the remote control sensor on the Screen.
•
To remove the batteries, perform the installation actions in reverse. Don't mix old or
used batteries with new ones. Close the cover securely.
•
Failure to match the correct polarities of the battery may cause the battery to burst or
leak, resulting in fire, personal injury, or ambient pollution.
Precautions To Take
•
Use the remote control within the specified range (within 10 m).
You may experience communication failures when using the device outside the coverage area or if there are obstacles
within the coverage area.
•
You may experience communication failures depending on the accessories.
Devices such as a microwave oven and wireless LAN operate in the same frequency band (2.4 GHz) as the Magic
Remote. This may cause communication failures.
•
The Magic Remote may not work properly if a wireless router (AP) is within 0.2 m of the Screen. Your wireless router
should be more than 0.2 m away from the Screen.
•
Do not disassemble or heat the batteries.
•
Do not drop the battery. Avoid extreme shocks to the battery.
•
Do not immerse the batteries in water.
•
Caution : Risk of fire or explosion if the battery is replaced by an incorrect type.
•
Properly dispose of used batteries.
Advertisement
Table of Contents
