Sanyo VDC-DP9585P Installation Manual page 3

3. Mount the camera unit
1
Connect the cables from the ceiling.
Push the excess of connected cables into
the ceiling.
For details on the connections, see page 5.
2
Free the locks (E) on the base chassis.
3
Mount the camera unit using the two
base screws (J).
Camera
unit
4
Push the sliding plate (D) in the arrowed
direction until it clicks, then connect the
pin connector cables from the camera
unit base to the circuit board.
The sliding plate must be between the
screws (K) and the base chassis for its
ends to be locked.
D
Do not adjust pan/tilt manually. They must be adjusted electrically.
E
J
K
4. Adjust/Check the video image
from the camera
A
Set up the camera remotely (see the
back of this manual).
B
Check the settings screen or camera
angle on a portable monitor (see the back
of this manual).
5. Install the dome cover
1
Align the logo on the dome cover and
the mark (L) on the camera unit base.
Accommodate the drop-prevention cable
neatly (no twists).
2
Tighten the four screws (A) firmly using
the hexagonal wrench (large).
L
A
For customers using the option board
(heater: VA-50H)
For this unit, the main board (A) is sufficient
to raise the temperature. Always be sure to
remove the sub board (B).
2
A
A
B