Removing The Speaker; Replacing The Speaker - Epson NX Service Manual

Removing the Speaker

Follow these steps to remove the speaker:
Remove the cover (see page 3-2) and any option cards that may be in the way (see
page 3-5).
Disconnect the speaker cable from CN3 on the system board
From the front of the chassis lift up on the lower speaker unit tab to release it from the
lower chassis mounting hole (see Figure 3-15).
From the backside of the front chassis, pull the bottom of the speaker unit up and
away from the front of the chassis.
From the backside of the speaker unit the speaker can be removed by pushing it out of
its holder.

Replacing the Speaker

Follow these steps to replace the speaker:
1
From the backside of the front chassis, insert the upper tab of the speaker unit into the
upper mounting hole and lower the bottom tab of the speaker unit down and into the
lower mounting hole in the front of the chassis (see Figure 3-15).
2
Connect the speaker cable to CN3 on the system board.
3
Replace any option cards removed and the cover.
assembly
Figure 3-15 Speaker and LED Assemblies
3-19