Epson DFX-9000 Reference Manual page 103

The printer exits the SelecType mode.
Note:
If you turn off the printer prior to exiting the SelecType mode, any
changes you may have made are canceled and not saved.
Changing the settings in the default-setting mode
The following table shows the basic function of each button in the
default-setting mode.
Button
ItemU (Font) button
ItemD (Pitch) button
SetU (Tear Off) button
SetD (Top of Form)
button
Follow these steps to enter the default-setting mode and change
the settings:
Note:
If you turn off the printer prior to exiting the default-setting mode,
settings that you have set up until you turn off the printer are saved.
1. Make sure paper is loaded and turn off the printer.
c
2. Turn on the printer while holding down the Font button to
enter the default-setting mode. The message Setting mode
appears on the LCD panel.
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise, you may damage the
printer.
Basic function
Selects the previous menu parameter.
Selects the next menu parameter.
Select the previous value in the selected menu.
Select the next value in the selected menu.
Control Panel
4
4
4
4
4
4
4
4
4
4
4
4
103