Notice For Windows Xp Users - Epson Aculaser C1100 Series Instruction Manual

Notice for Windows XP Users

To use this product on the computer running Windows XP Service
Pack 2, follow the steps below to change the settings in Windows
Firewall.
Note:
If you register programs to Windows Firewall as exceptions, ports used
by the programs are open to incoming communications from an external
network. Each time that you allow an exception for a program to
communicate through Windows Firewall, your computer is made more
vulnerable. If you have many exceptions and open ports, your computer
can become a victim of unknown intruders or viruses. Epson takes no
responsibilities for damages caused by allowing exception in Windows
Firewall.
A. Configuring the Network Interface using EpsonNet
EasyInstall
If you configure the network interface using the computer
running Windows XP Service Pack 2, follow the steps below to
register the network configuration utility (EpsonNet EasyInstall
or EpsonNet Config) to Windows Firewall as exceptions;
otherwise you cannot configure the network interface because it
is not displayed on the screen of the network configuration utility.
1. Insert the software CD-ROM in the CD-ROM drive.
Note:
❏ If the installation screen appears, click Exit.
❏ Do not eject the software CD-ROM before the registration is
completed.
2. Click Start, point to Control Panel, and then select Security
Center. Click Windows Firewall.
280
Notice for Windows XP Users