Epson Aculaser C1100 Series Instruction Manual page 12

❏ Do not dispose of used toner cartridge, photoconductor units,
or fuser units in fire, as they can explode and cause injury.
Dispose of them according to local regulations.
❏ If toner is spilled, use a broom and dustpan or a damp cloth
with soap and water to clean it up. Because the fine particles
can cause a fire or explosion if they come into contact with a
spark, do not use a vacuum cleaner.
❏ Wait at least one hour before using a toner cartridge after
moving it from a cool to a warm environment to prevent
damage from condensation.
❏ When removing the photoconductor unit, avoid exposing it
to room light for more than five minutes. The unit contains a
blue-colored light-sensitive drum. Exposure to light can
damage the drum, causing dark or light areas to appear on
the printed page and reducing the service life of the drum. If
you need to keep the unit out of the printer for long periods,
cover it with an opaque cloth.
❏ Be careful not to scratch the surface of the drum and belt.
When you remove the photoconductor unit from the printer,
always place the unit on a clean, smooth surface. Avoid
touching the drum, since oil from your skin can permanently
damage its surface and affect print quality.
❏ To get the best print quality, do not store the photoconductor
unit in an area subject to direct sunlight, dust, salty air, or
corrosive gases (such as ammonia). Avoid locations subject to
extreme or rapid changes in temperature or humidity.
❏ Be sure to keep consumable components out of the reach of
children.
❏ Do not leave jammed paper inside the printer. This can cause
the printer to overheat.
❏ Avoid sharing outlets with other appliances.
12