Getting Started - Hisense U7 Series Quick Setup Manual

Getting started

Step 1. Attach stand or mount
Before you start using your TV, attach your TV stand or mount it on the wall.
CAUTION:
• Disconnect the AC power cord before installing a stand or a wall mount bracket.
• The LED display on your TV is fragile. Make sure the TV screen is not scratched or
damaged by hard objects or from pressure.
• After the installation is complete, make sure the TV is steady on a table or firmly
attached to a wall mount, before removing all protective film, if any.
Attach the TV stand
To attach the TV stand legs to your TV:
1. Carefully place your TV face down on a clean, soft and flat surface.
2. Insert the TV base stands into the bottom slots on your TV.
3. Use the screws provided to secure each base stand tightly.
55" (139.7cm)
Screws:
M5×12
65" (165.1cm) / 75" (190.5cm)
Note: If your table is long enough to place the TV on top of, then insert the stands into
the screw holes 'A' that are shown in the illustration. If your table is NOT long enough,
then insert the stands into the screw holes 'B' that are shown in the illustration. Note
that these two installation methods types cannot be mixed.
A
Base Stand
Screws:
M5×12
Base Stand
A
Base Stand
Screws:
M5×12
Screws:
M5×12
Base Stand
2
Base Stand
Base Stand
B
Screws:
Screws:
M5×12
M5×12
B