Beamz Scene Setter DMX-024PRO Instruction Manual page 6

General Description
This digital DMX 'scene setter ' light controller can control 24 light channels and gives total dimmer control over all 24
outputs. It features 48 easily programmable memories with a storage capacity for 99 different light effect scenes per
memory. It can be set on automatic control or on music control via the built-in microphone or via an external audio signal.
The speed and fade time for the running light are also selectable. The digital DMX-512 control uses "addresses" for the
individual control of the connected light units. These outgoing addresses are pre-set to the numbers 1 to 24.
Controls and Functions
1) Indicator LEDs for the setting of the slider controls from section A.
2) 12 slider controls adjusting the light intensity of channel 1 to 12.
Push-buttons with 'flash' function for channel 1 to 12.
3)
4) Indicator LEDs for the setting of the slider controls from section B.
5) LED indicating the active scenes.
6) Slider controls for the channels 13 to 24.
7) Flash buttons 13 to 24 allowing to completely switch on shortly one channel.
8) MASTER A slider control for the setting of the light intensity on channel 1 to 12 (section A) or on all 24 channels
simultaneously.
'BLIND' button to exclude one or more channels simultaneously from a scene pattern. The light intensity of that channel will
9)
then be determined by the appropriate slider control of the channel.
10) MASTER B slider control setting the light intensity of channels 13 to 24.
11) 'HOME' button to switch off the 'Blind' function.
12) Slider control for the setting of the fade time between the scenes.
13) TAP SYNC button to synchronize the STEP rhythm with the music.
14) SPEED slider control to set the STEP speed of the running light patterns.
15) 'FULL-ON' button to switch all outputs to 100% intensity.
16) AUDIO LEVEL slider control to set the sensitivity of the built-in microphone or of the audio signal that is fed into the LINE-IN
input.
17) BLACK OUT button switches all outputs to zero. The yellow LED is flashing.
18) STEP button to activate the following scene.
19) AUDIO button switches the music control on.
20) HOLD button stops the execution of all pattern steps.
21) PARK button to select between individual or mixed running light patterns.
22) REC EXIT button has two functions: a) in programming mode you can choose between ADD or KILL function of a scene, and
b) leave the programming mode.
23) RECORD button to store the scenes in programming mode.
24) PAGE/REC CLEAR button to select a memory page from 1 to 4.
25) MODE SELECT button to choose among automatic running light (red) or single (yellow) or double pre-set (green).
26) DARK button to switch all outputs to zero regardless of the FULL-ON button.
27) ALL REV/EDIT button: push to invert the running direction of all scenes.
28) % OR 0-255 button changes the indication on the display.
29) DELETE/REV ONE button inverts the running direction of a determined scene.
30) UP/CHASE REV button to invert the running direction of the current running light program.
31) DOWN/BEAT REV. Button inverts the running direction in music controlled mode.