Related Documentation; Safety Information - National Instruments CVS-1450 Series Getting Started

• Ring and back lights
• NI Vision I/O Terminal Block and Prototyping Accessory (part number 779166-01)
• DIN rail/panel mount kit (part number 189154-01)
• Digital I/O cable and horizontal DIN rail terminal block (part number 778790-01)
• Digital I/O cable and vertical DIN rail terminal block (part number 778791-01)
• 75 Ω SMB 111 coaxial cable (part number 763422-01)—SMB to BNC cable for connecting to
triggers and light sources
Visit
ni.com
products.

Related Documentation

The following documents contain additional information that you may find helpful:
• NI CVS-1450 Series User Manual—Contains information about programming options, hardware
functionality, and signal connections.
• NI Vision Acquisition Software Release Notes—Outlines new functionality, system requirements,
installation procedures, and descriptions of the documentation included with the NI-IMAQdx
driver software.
• Measurement & Automation Explorer Help for NI-IMAQdx—Describes how to configure the
NI-IMAQdx driver software, NI interface devices, and cameras using Measurement & Automation
Explorer (MAX).
• NI-IMAQdx Help—Contains fundamental programming concepts for the NI-IMAQdx driver
software and terminology for using NI image acquisition devices.

Safety Information

Caution The following paragraphs contain important safety information you must follow when
installing and operating the device.
Do not operate the device in a manner not specified in the documentation. Misuse of the device may
result in a hazard and may compromise the safety protection built into the device. If the device is
damaged, turn it off and do not use it until service-trained personnel can check its safety. If necessary,
return the device to National Instruments for repair.
Keep away from live circuits. Do not remove equipment covers or shields unless you are trained to do
so. If signal wires are connected to the device, hazardous voltages can exist even when the equipment is
turned off. To avoid a shock hazard, do not perform procedures involving cover or shield removal unless
you are qualified to do so. Disconnect all field power prior to removing covers or shields.
If the device is rated for use with hazardous voltages (>30 V
safety earth-ground connection wire. Refer to the device specifications for maximum voltage ratings.
Because of the danger of introducing additional hazards, do not install unauthorized parts or modify
the device. Use the device only with the chassis, modules, accessories, and cables specified in the
installation instructions. All covers and filler panels must be installed while operating the device.
Do not operate the device in an explosive atmosphere or where flammable gases or fumes may be
present. Operate the device only at or below the pollution degree stated in the specifications. Pollution
consists of any foreign matter—solid, liquid, or gas—that may reduce dielectric strength or surface
resistivity. The following is a description of pollution degrees.
Getting Started with the NI CVS-1450 Series
or call the National Instruments office nearest you for more information about these
, 42.4 V
rms
2
, or 60 V ), it may require a
pk dc
ni.com