Electrolux EI23CS65KS Use And Care Manual page 41

Ice Dispenser
Concern
Cause
• Water supply is not
Dispenser will not
dispense ice. connected.
• Household water line to
the refrigerator is kinked.
• Ice storage container is
empty.
• Freezer temperature is set
too warm.
• Household water line valve
is not open.
• Freezer door is not closed.
• Ice dispensing arm has
been held in for more than
4-5 minutes.
• Ice has melted and
Ice dispenser is
jammed. frozen around auger
due to infrequent use,
temperature fluctuations,
and/or power outages.
• Ice cubes are jammed
between ice maker and
back of ice container.
• Ice cubes are frozen
together.
• Ice cubes are hollow or
smaller than normal.
Before You Call
Solution
• Connect water supply (see Connecting The Water
Supply section).
• Unkink the water line. If it is a copper line, it should be
replaced because of possible leaks at the kink. A copper
line should be coiled behind the unit to avoid kinking.
• Ensure ice maker is turned on. When the first supply of
ice is dropped into the container, the dispenser should
operate.
• Turn freezer control to a higher setting so that ice cubes
will be made. When first supply of ice is made, dispenser
should operate.
• Open household water line valve. Allow sufficient time
for the ice to be made. When ice is made, the dispenser
should operate.
• Ensure freezer door is closed. (See Problem Section,
Opening/Closing of Doors/Drawers)
• Motor is overloaded. Motor overload protector will reset in
approximately 3 minutes. Ice can then be dispensed.
• Remove ice container, thaw, and empty the contents.
Clean container, wipe dry, and replace in proper position.
When new ice is made, dispenser should operate.
• Remove ice cubes that are jamming the dispenser.
• Use the dispenser often so that cubes do not freeze
together.
• The ice & water filter cartridge could be clogged. Replace
the filter cartridge. Dispensing system operates best at 30-
100 psi water pressure. Well water pressures should fall
within this range.
41