Removing The Doors - Electrolux EI23CS65KS Use And Care Manual

8

Removing The Doors

Getting through narrow spaces
If your refrigerator will not fit through an entrance area, you can reduce its size by removing the doors.
Check first by measuring the entrance.
Required Tools
You will need the following tools:
Top Hinge
Cover Front
Screw
Top
Hinge
Screw
To prepare for removing the doors:
1 Make sure the electrical power cord is unplugged from the wall outlet.
2 Open both doors and remove the toe grille (as explained in the
Installation Instructions that came with your appliance).
3 Remove any food from the door shelves.
4 Close the doors.
To remove the refrigerator top hinge cover:
1 Remove the three screws from each cover over the top door hinges.
2 Lift hinge cover straight up and off.
To remove the refrigerator door:
1 Trace lightly around the door's top hinge with a pencil. This makes
reinstallation easier.
2 Remove the two screws from the top hinge. Lift the door off of the
bottom hinge and set it aside.
3 Remove the two bottom hinge screws and hinge if necessary.
To reinstall the refrigerator door, reverse the above steps.
Top Hinge
Tools Necessary:
Cover Rear
Screw
Bottom
Hinge
Screw
Phillips Head
Adjustable Hinge
(some models)
AND
Socket
™
Wrench Set
Non-Adjusting Hinge
(some models)
OR OR
Adjustable
Wrench
CAUTION
Be sure doors are
set aside in a secure
position where they
cannot fall and cause
personal injury.
3/8" Fixed
Wrench