Renault Clio User Manual page 177

TYRE PRESSURE LOSS WARNING
The table below shows the possible messages related to the tyre resetting procedure.
Steps Messages
– Tyre pressure init. at stop
1 Tyre pressure init. long press
2 If pressure OK [hold on]
3 Operation completed
(4/6)
The message is displayed during driving. If you want to reset the pressure of the
four tyres, stop the vehicle.
To reset the pressure of the four tyres, with the vehicle stopped, press and hold
the 5 OK switch to launch resetting until the "If pressure OK [hold on]" message
is displayed.
The message flashes to indicate that the system has registered the resetting
procedure. If all four tyres have been correctly adjusted to match the tyre pres-
sure values recommended on the tyre pressure label ➥ 4.11, press and hold
switch 5 OK until the message "Operation completed" appears.
The resetting procedure has been completed successfully. You can now drive.
Readings
2.41