Mounting System Installation - GE PNRQ15RBL Owner's Manual & Installation Instructions

REVERSE OSMOSIS ASSEMBLY

MOUNTING SYSTEM INSTALLATION

Choose a location under the sink to mount the
system. Location should be easily accessible, with
adequate clearance between the bottom of the
filter cartridges and the floor or bottom of the
cabinet for removal of filter cartridges. Allow
enough space on either side of the system for the
tubing connections.
1. Remove the prefilter and postfilter cartridges.
2. Remove the assembly cover by unlocking the
four tabs on the cover from the system.
To remove
Prefilter
3. Use a flat-head screwdriver to work from left to
right from the underside of the system.
4. Use the icons on the bottom of the system for
screwdriver positioning.
Screwdriver positioning
System opening
Installation Instructions
To remove
Postfilter
Tab
Screwdriver
9
5. Hold the Reverse Osmosis assembly up to the
wall surface where you wish to install it. Mark
location for screws. There should be a
minimum of 17" from the marks to the bottom
of the cabinet floor.
Screw locations
IMPORTANT
— Do not get dirt or debris
inside the assembly area. Use only to mark
mounting hole locations.
6. Install screws to the wall, leaving a 3/16"
clearance between the head of the screw and
wall (drill pilot holes if needed).
7"
17"
7. Hang the Reverse Osmosis assembly on the
screws. Tighten or loosen the screws as desired
until the system is secure on the wall.
8. To install the
cover, line up the
front
tabs on the
cover with the
openings
in the system.
9. Snap the cover
in place; the tabs
will flex, allowing
the cover to
snap in place.
10. Remove the
membrane
cartridge.
Membrane
3/16"
Screws
Wall
Screw
To remove