Advertisement
Take out, clean and install the ice
cube box
lf the ice maker isn't used for a long
period, ice cubes that are just
produced might have unpleasant
smell. You must take out and clean
the ice cube box.
Open the upper drawer in the freezer
compartment, rotate the knob of ice
maker counterclockwise by 90, turn
the handle from the horizontal position
to vertical position to release the lock
(as shown in Fig. 1 of Pg. 14), pull it
out (as shown in Fig. 2 of Pg. 14) and
take out the ice cube box.
Rinse the ice cube box with warm
water (below 60℃) and don't use
detergent.
Dry the ice cube box completely in air
in case that water droplets in the ice
cube box might cause abnormal
functioning of the ice maker.
When the ice maker can't move,
separate the ice maker as shown in
Fig. 1 and Fig.2. Then install after ice
cubes are melted.
Insert the ice cube box onto the rack
according to original sequence and
rotate to the locked position.
15
Fig.3
Locked status
Fig.3
Unlocked status
Take out and install the ice maker
When the ice maker isn't used, it
could be taken out and the vacated
space could be used as a part of the
freezer compartment.
Push the Ice Maker button on the
control panel at the refrigerator door
and the icemaking sign disappears.
Open the door and take out the
drawer.
Pull the ice-maker out (as shown in
Fig.1), and then downwards, so that
the ice maker is unhooked (as shown
in Fig. 2).
Pull down the ice maker's power plug
so that it is detached from the ice-
maker's power socket (as shown in
Fig. 3)
Install the ice maker into the original
position, push the Ice Maker button,
the ice-making symbol appears.
Close the door after the ice maker is
installed to the proper place,
otherwise, it might damage the ice
maker.
Ice maker's
power socket
Ice maker's
power plug
1
3
2
Ice
maker's
hook
6
Advertisement
