Installation Instructions Remove exterior and interior packings, wipe the outside thoroughly with a soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing the unit in a narrow recess or near any heat source, direct sunlight, or moisture. Let air circulate freely around the unit.
Page 5
FEATURES Freezer Shelf Freezer Temperature Control Panel Adjustable TemperatureControl Interior Light Light Switch Full-Width Glass Shelves Clear Crisper Leveling Legs Freezer Door Bins Small Door Bins Can Storage Large Door Bins...
Operating Instructions REFRIGERATOR TEMPERATURE CONTROL Your refrigerator will automatically maintain the temperature level you select. The temperature control has 3 settings. COLD is the warmest setting, COLDEST is the coldest setting. The temperature setting is cycle change among “COLD”, “COLDER” and “COLDEST”, when you push the “SET” button. At first, set the panel to the “COLDER” indicator marking (middle setting), and allow 24 hours to pass before adjusting the temperature to your need.
Care and Maintenance COOLING SYSTEM This refrigerator is inclusive of a “Frost Free” type cooling system, which means you never have to defrost the freezer compartment. The defrost water is routed into a defrost pan located near the compressor, where it then evaporates. CLEANING Before cleaning the refrigerator or freezer, always disconnect the refrigerator from the power supply.
DOOR REVERSAL INSTRUCTIONS Tool required: Philips screwdriver, flat bladed screwdriver, hexagonal spanner. Ensure the unit is unplugged and empty. To take the door off, it is necessary to tilt the unit backwards. You should rest the unit on something solid, so that it will not slip during the door reversing process. All parts removed must be saved to do the reinstallation of the door.
Page 9
5. Move the hinge hole covers from left side to right side. 6. After removing the refrigerator door hinge, remove the screw cover from the upper left side of refrigerator door frame, then insert the cover into the hinge hole on the right of door frame.
Page 10
REINSTALLATION 1. Take a new bottom hinge from the user manual bag. Align the holes in the bottom hinge to the corresponding holes on the left side of the cabinet. Insert and tighten the screws. Reinstall both front feet. Install the short leveling leg on the left side, and the long leveling leg on the right side.
Troubleshooting Occasionally, a minor problem may arrise, and a service call may not be necessary- use this troubleshooting guide for a possible solution. POSSIBLE CAUSE PROBLEM SOLUTION • Check connection of power cord • No power to unit. at power source. 1) Unit does not work.