Horizon Yacht Charters FP Lucia 40 2020 Information & Operation Manual page 51

Outboard start procedure:
1. Place Kill cord under kill switch (Dinghy driver must always wear the kill cord).
2. Open vent on fuel tank cap (this vent can stay open; it allows air out but will not
allow water to go in). The fuel tank is in the dinghy bow locker.
tank expands in this climate and if the vent is left closed it can damage
the tank and cause a fuel leak.
3. Few pumps on fuel line bulb.
4. Make sure outboard is neutral.
5. Add some revs using throttle on tiller handle.
6. Pull on start pull cord.
7. If the outboard does not start then pull choke and try again, as soon as the
outboard starts push choke back in.
Outboard
Tilt lever
The fuel in the
Pull cord
Throttle and tiller
Gear shift
arm
Kill cord and kill switch
Choke