Table of Contents
Advertisement
S queeze the two red release buttons inwards and
Soak the brewing unit in water for about 5 minutes, then rinse.
After cleaning, replace the brewing unit (A5) by sliding it onto the
internal support and pin at the bottom, then push the "PUSH" symbol
fully in until it clicks into place.
Note: If the brewing unit is difficult to insert, ensure the piston is fully
inserted by pressing it firmly from the bottom and top as shown here:
Once inserted, make sure the two red buttons have snapped out.
Replace the drip tray and waste coffee container.
Close the service door.
at the same time pull the brewing unit outwards (fig.
29).
Important: Do not use washing up liquid to clean
the brewing unit. It would remove the lubricant
applied to the inside of the piston.
31
Advertisement
Table of Contents
