Cleaning; Cleaning Under The Mower Deck; Disposing Of Waste - Toro Z Master Professional 500 Series Operator's Manual

Figure 100
1. Bolt
2. Spacer
3. Locknut
4. Spring
3. Place the spacer and the spring onto grass
deflector.
4. Place 1 J-hook end of the spring behind the
deck edge.
Note:
Make sure that 1 J-hook end of the
spring is installed behind the deck edge before
installing the bolt as shown in
5. Install the bolt and the nut.
6. Place 1 J-hook end of the spring around the
grass deflector (Figure
Important:
The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the
full down position.
g015594
5. Spring installed
6. Grass deflector
7. J-hook end of spring
Figure 100.
100).

Cleaning

Cleaning under the Mower
Deck
Service Interval: Before each use or daily
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Raise the mower deck to the T
position.

Disposing of Waste

Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
63
RANSPORT