Table of Contents
Advertisement
7. Slowly pour electrolyte into each cell until the level is
once again up to the upper line on the battery case
(Fig. 2) and install covers.
8. Tilt the top of the battery rearward and slide it into the
traction unit.
Important
Do not allow the battery posts to touch the
frame or hydraulic lines or it may cause sparks.
9. Secure the battery in chassis with the clamp, bolts, and
nuts removed previously (Fig. 1).
10. Using the bolt and nut supplied with the battery,
connect the positive (red) cable to the positive (+)
battery post (Fig. 1). Slide the rubber cover over the
battery post.
11. Using the bolt and nut supplied with the battery,
connect the negative (black) cable to the negative (–)
battery post (Fig. 1).
Note: Ensure that the battery cables do not contact any
sharp edges or each other.
12. Close the rear access cover.
13
Advertisement
Table of Contents
