Table of Contents
Advertisement
Listening to the iPod, iPhone or iPad (continued)
For iPod nano or iPod touch :
For additional support, apply dock spacer (supplied) as shown.
Peel off
separator
Dock spacer
1
Peel off the double sided tape separator.
2
Place the spacer between the two ribs of the iPod docking
cover as shown.
■ iPod or iPhone playback
1
Press the ON/STAND-BY button to turn the power on.
2
Press the iPod button on the remote control or FUNCTION
button repeatedly on the main unit to select iPod function.
3
Insert iPod or iPhone unit into the dock of main unit. "DOCK
OK" will appear.
4
Press the
/ (iPod
/ ) button to start playback.
■ Navigating the iPod, iPhone or iPad
menus
1
Press the iPod MENU button to view the menu on iPod,
iPhone or iPad unit. Press it again to go back to previous
menu.
2
Use the PRESET (
or
menu and then press ENTER button.
Note:
When navigating the iPod, iPhone or iPad menu with remote
control, do not operate any of the buttons on the iPod or iPhone
unit. The volume level is adjusted by pressing the VOL (+ or –)
button on the main unit or the remote control. Adjusting the
volume on the iPod, iPhone or iPad units give no effect.
iPod, iPhone and iPad operations:
The operations described below depend on the generation iPod,
iPhone and iPad you are using.
System on operation:
When the main unit is powered on, the iPod, iPhone or iPad units
will automatically power on when docked or connected in the unit.
System off (stand-by operation):
When the main unit is turned to stand-by mode, the docked iPod,
iPhone or connected iPad unit will automatically turn to stand-by
mode.
Rib
iPod
docking
cover
) button to select an item on the
■ To disconnect iPod, iPhone or iPad
Simply remove the iPod or iPhone from the docking station
or iPad connector from USB terminal. It is safe to do so
even during playback.
Caution:
● Unplug all accessories for the iPod or iPhone before
inserting it into the docking station.
● Stop button ( ) at main unit is invalid during iPod
function.
■ Various iPod, iPhone and iPad functions
Function Main unit
Dock/USB
Play
Pause
Track up/
down
Fast
forward/
reverse
____
Repeat
Shuffle
____
Menu
____
Enter
____
Cursor
Up/Down
E-10
Remote control
Operation
Dock
USB
Press in the pause
mode.
Press in the
playback mode.
Press in the
playback or pause
mode.
If you press the
button in the pause
mode, press the
button to start the
desired track.
Press and hold
down in the
playback mode.
Release the button
to resume
playback.
Press to toggle
repeat mode.
Press and hold
to toggle shuffle
mode.
Press to view the
iPod menu during
iPod function.
Press to confirm
the selection.
Press to select the
iPod menu.
/
Advertisement
Table of Contents
