Table of Contents
Advertisement
9. Press the Footswitch.
10. As the materials feed into the rollers, pull the
release liner off the decal.
11. Continue until the decal and substrate exits the
rollers.
t
Ips
•
For larger graphics, a second person at the
back of the laminator can help apply tension
to the decal. This frees up the person in the
front of the laminator to clean up materials and
handle the release liner.
•
If the release liner gets caught in the rollers,
stop the laminator and reverse the materials
out of the rollers until you can pull out the
release liner.
•
Do not allow the materials to stop under
the pressure of the rollers for any extended
time. This can cause indentations on softer
substrates.
Page 6-10
SPIRE III Series – Installation and Operating Instructions
p
ressure
p
recoat
Use this process to mount a graphic to a precoated
substrate.
Examples include POP signage, legal graphics,
photographs, and presentations.
NOTE: In the following illustration, depending on
the laminator model, you may or may not have Pull
rollers.
Figure 51. PSA mounting precoat diagram.
To mount a graphic:
1. Press STOP.
2. Set the Main Roller gap to the thickness of the
substrate.
3. Pull 1 to 2 inches (25 to 51 mm) of release liner
off the substrate.
4. Line the graphic up with the edges of the board
and then starting in the middle, tack the leading
edge of the graphic to the substrate.
5. Insert the board into the roller nip, making sure it
is entering the rollers straight.
6. Using the Footswitch, feed the board into the
rollers to the point where the liner separates from
the substrate.
7.
Place the graphic over the top of the roller and
through towards the back of the machine.
8. Place one hand on top of the roller to hold the
graphic, and with the other hand, grab the
release liner.
s
m
ensItIve
ountInG
- F
ront
U
R
MR
P
P
MR
U
-
R
R
Advertisement
Table of Contents
