screw the new sides on and reconnect the
power supply
Cut the cables coming out from the glass side and apply
the Red female connectors provided with the material
supplied
Repeat on the other side
screw the front support
blocks on the glass sides
Replace the glass top and screw it to the holes on
the sides, making sure to place the long screw
above and the short one below
Long screw
over
Short screw
under
Apply the clear adhesive thickness supplied on the
outer rim and top of the glass side
cut the Strip just before the top block
do not go beyond this point with the
adhesive
on the new glass front supplied we have already
applied the adhesive, so it's ready to be mounted