Advertisement
remove the bumpers
unscrew the bumpers
unscrew the fixing screws
of the front on both sides
unscrew the fixing screws of the
side (below)
unscrew the fixing screws of the
side (above)
remove the side panels
Cut power cables on either side of the front glass
attention! on each side there are 2 cables:
1 is the hot wire of the flavour tags holder and should
not be trimmed
be careful not to cut the hot wire under the
flavour tags holder
Unscrew the blocks supporting the front
retain all screws for later and pay attention to
the plastic pin on each screw, screw it until
the screw head
You can now remove the
front
cut front power cable: it will be
reconnected to the new front
Advertisement
