Water Hardness Setting; 水硬度設定 - DeLonghi My Machine NESPRESSO EN550.BM Manual

WATER HARDNESS SETTING/

1 sec.
1. Place the water hardness 2. The number of red squares
sticker under water for 1 second. indicates the water hardness
1. level.
放置水硬度貼於水
2.
紅方格內的數字顯示
中1秒。
水硬度。
Water hardness table/
水硬度表
Latte Macchiato
Cappuccino
Warm milk froth/*
Warm milk froth/* +
+
Latte Macchiato
Warm milk froth/* +
+
Cappuccino
*
暖奶泡的份量
7484_UM_LATTISSIMA_RESTYLE_Z3B.indb 25
水硬度設定
0
1
2
3
4
3. Switch the machine ON.
3.
啟動咖啡機。
NOTE: remove milk jug.
注意：
移除牛奶壺
Level/ dH fH mg/L CaCo3
級別
0 <3 <5 <50
1
>4 >7 >70
2 >7 >13 >130
3 >14 >25 >250
4 >21 >38 >380
3 sec.
Descaling
Clean
4. Press the Latte Macchiato and Warm milk froth
buttons simultaneously for 3 seconds to enter Menu
mode: descaling and clean alerts start blinking.
4.
同時按下Latte Macchiato及暖奶泡按鈕3
秒以進入目錄： 除鱗以及清洗指示燈
會閃動。
5. Touch in a single continuous movement the following buttons:
Latte Macchiato ->Cappuccino ->Warm milk froth. The current water
hardness setting is indicated by the corresponding buttons (steady light).
5.
連續依序按以下按鈕： Latte Macchiato ->Cappuccino ->暖
奶泡。 目前的水硬度設定會以相關的按鈕顯示 （穩定
燈號） 。
6. Now, within 15 sec, you can set the desired value by
pressing the corresponding button. They blink 3 times
rapidly to confirm new value.
6.
現在於15秒內， 您可按相關按鈕以設
定所想的水硬度值。 按鈕會快速閃燈3
次以確定新的水硬度值。
NOTE: the Menu mode exits
automatically after 30 sec. if no actions
are performed. It can be exit manually by
pressing the Latte Macchiato and Warm
milk froth buttons simultaneously for
3 seconds.
注意： 於30秒後自動離開目
錄。 若未能自動離開， 可以手動
操作： 同時按Latte Macchiato及暖奶
泡按鈕3秒。
7. The menu exits automatically and machine
returns to ready mode.
7.
自動離開目錄， 咖啡機返回待
機模式。
23.09.14 10:34
EN
HK
25