JVC XV-N212S Service Manual page 10

3.1.4 Removing the rear panel (See Figure 7 )
• Prior to performing the following procedure, remove the top
cover.
(1) Remove the seven screws D attaching the rear panel.
(2) Disconnect the power cord from connector
power supply board
3.1.5 Removing the main board and power supply board. (See Figure 8)
• Prior to performing the following procedure, remove the top
cover/front panel assembly/rear panel.
(1) Remove the two screws E attaching the main board.
(2) Disconnect the card wire from connector CN201, CN202,
CN101 on the main board.
(3) Disconnect the flat wire from connector
supply board.
(4) Remove the four screws F attaching the power supply
board.
1-10 (No.XA016)
CN1 on the
Power supply board
CN2 on the power
Power supply board
CN1 Rear panel
D
Fig.7
E
F F
F CN2 F
Fig.8
D
CN202
E
CN101
CN201 Main board