Operation & Use - T-SPA TRIANNA T920 User Manual

OPERATION & USE
Mixer
Discharge pump switch
(optional)
1. To fill water:
The foot-spa is provided with a single hot and cold mixing valve located on the front of your spa.
This is a pressure balance valve that requires you to lift the handle to start the water flow and to adjust to
the temperature that is desired. The clean jet body must be completely submerged in water.
CAUTION: DO NOT USE FOAMING, SUDSING OR MINERAL OIL BASED ADDITIVES IN THE WATER.
2. To start whirlpool:
Press the button as shown. This will start your Clean Jet motor. You may stop the whirlpool function at any
time by pressing the button again.
3. To drain Foot-spa bowl:
Turn drain control knob to "pop-up" drain plug.
- If gravity drain (no discharge pump); water in bowl empties with duration determined by waste water
plumbing
- If optional discharge pump has been installed; then press discharge pump button to activate 2-
minute timer-controlled pump. Average drain time approximately one minute (depending on
plumbing characteristics).
4. The massage chair's manual book will be sent separately.
Note: Read and Follow Chair Manual Instructions
BASIC PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE
FOLLOWING:
Read and follow all instructions
DANGER. To reduce the risk of injury, do not permit children to use this unit
unless they are supervised at all times.
Use this unit only for its intended use as described in this manual. Do not
use attachments that are not recommended by the manufacturer.
Never drop or insert any object into any opening.
Do not block jets during whirlpool operation.
The unit must be connected to an electrical supply circuit that is protected by a ground
fault circuit interrupter.
The clean jet motor is magnetically driven and is insulated twice. Therefore, it
does not require to be bonded. Save these instructions
Overflow
Ventilation
14 | P a g e