1.SM (5 feet) of this hydro massage bathtub. CAUTION: Test the ground fault circuit interrupted protecting this appliance periodically in accordance with the manufacturer’s instructions T-SPA MFG, LLC 10510-10520 Kinghurst St Houston, TX 77099 Page 3 Version: T-900 ☏...
Page 4
WARNING: It is very important that you carefully follow the basin cleaning procedures on page 17 to ensure that the spa is sanitized after each use. T-SPA is not liable for any infections or disease that may result from improper cleaning or failure to adhere to sanitation requirements.
Page 5
Misuse or failure to properly clean pedicure spa unit may result in serious health issues, bodily injury, and/or death. T-SPA MFG, LLC 10510-10520 Kinghurst St Houston, TX 77099 Page 5 Version: T-900 ☏...
Page 6
Do not modify the plug provided with the product for any reason; if it will not fit the outlet, have a proper outlet installed by a qualified electrician. T-SPA MFG, LLC 10510-10520 Kinghurst St Houston, TX 77099 Page 6 Version: T-900 ☏...
Page 7
30 minutes. Failure to turn the chair off may result in the chair starting unexpectedly when the device cools. T-SPA MFG, LLC 10510-10520 Kinghurst St Houston, TX 77099 Page 7 Version: T-900 ☏...
Align the seat with pre-drilled holes on the base then tightly secure with provided nuts and bolts. Attach trays or remote stand to armrest with provided screws. VERSION: T-900 MODEL: TRI PEDICURE CHAIR T-SPA MFG, LLC 10510-10520 Kinghurst St Houston, TX 77099...
Page 12
6. Firmly hold the whirlpool jet cover and gently place it onto the round magnetic field. DO NOT release the hydro whirlpool jet cover until jet cover is on the round magnetic housing. T-SPA MFG, LLC 10510-10520 Kinghurst St Houston, TX 77099 Page 12 Version: T-900 ☏...
Page 13
MAGNET JET SPECIFICATIONS Model: MAGNA JET – 120 VAC, 60 Hz, 1.0 A Pump: Hydro Dual-Massage Jet Flow Mounting: Single 3.5”-diameter hole with auto tighten mounting screws (4) T-SPA MFG, LLC 10510-10520 Kinghurst St Houston, TX 77099 Page 13 Version: T-900 ☏...
Page 14
6. Handheld sprayer. It has complied with applicable requirements of ASME A112.18.1-2005/CSA B125.1-05 FAILURE TO ANCHOR THE BASE MAY RESULT IN PERSONAL INJURY OR DAMAGE TO UNIT. DAMAGE AS A RESULT WILL VOID THE WARRANTY. T-SPA MFG, LLC 10510-10520 Kinghurst St Houston, TX 77099 Page 14 Version: T-900 ☏...
If optional discharge pump system is installed: press Drain/Pump button to activate discharge pump motor. Average drain time approximately one minute (depending on plumbing characteristics). 4. MASSAGE CHAIR MANUAL BOOK WILL BE SEND SEPARATELY T-SPA MFG, LLC 10510-10520 Kinghurst St Houston, TX 77099 Page 17 Version: T-900 ☏...
Page 18
7. The clean jet motor is magnetically driven and is insulated twice. Therefore, it does not require to be bonded. Save these instructions! T-SPA MFG, LLC 10510-10520 Kinghurst St Houston, TX 77099 Page 18 Version: T-900 ☏...
NOTE: The use of oil-based products can build up in the whirlpool system, causing clogging in the jets. Adherence to the above cleaning will minimize build up. T-SPA DO NOT recommend the use of mineral oil-based products. Cleaning or sanitizing is NOT disinfecting. According to the Centers of Disease...
Page 20
After checking underside for leaks, turn on whirlpool system by pushing Jet button and watch for leaks as water circulates. Let the tub run on full cycle. Open drain plug to discharge T-SPA MFG, LLC 10510-10520 Kinghurst St Houston, TX 77099 Page 20 Version: T-900 ☏...
WARRANTY & SERVICE T-SPA warrants to the original purchaser that the new pedicure spa will be free from defect during the Standard Warranty Period (listed below). The shipping date and the uniquely coded Serial Number on the back of each spa chair will justify the start of the warranty period for the product.
Page 22
4. All parts are to be shipped by Ground services, average of 2-5 days. 5. All defective parts must be shipped back to T-SPA within 30 days of receiving the new replacement parts or warranty will be void. 6. Any warranty claim that cannot be determined over the phone call, the customer must send photos to T-SPA for inspection related.
To validate the limited warranty, Limited Warranty Registration Form MUST be filled out completely and return to T-SPA within 30 days of original purchased date. This Limited Warranty is valid if T-SPA received the registration form from the original purchaser.
Need help?
Do you have a question about the T-900 and is the answer not in the manual?
Questions and answers