Advertisement
4. Switch on the power supply.
5. Program the time of lifting/lowering the roller blind.
Scheduling time of activation
Time of activation can be programmed upon the assumed time
of roller blind operation or by activating the roller blind for the
test run:
Scheduling for the specified time
1. Press and hold (for approx. 4 s) the ���� key until the green
U LED will begin to flash slowly. The controller is now ready
for programming.
2. Short press ���� key – the controller starts to measure out
the activation time, which is indicated by rapid flashing of U
LEDs.
3. After the time has been measured out, press the ���� key
again. The controller will save the elapsed time in non-volatile
memory and then exit the programming mode, which is indi-
cated by the constant U LED light.
Test run
1. Place the blind in the outmost top or bottom position.
2. Press and hold (for approx. 4 s) the ���� key until the green
U LED will begin to flash slowly. The controller is now ready
for programming.
3. Short press the local control �� or ���� key (in the opposite
direction to the current position of the roller blind). The con-
troller starts the motor and begins to measure out the time.
4. After the time has been measured out, press any of the local
control keys. The roller blind motor will stop and the controller
will save the elapsed time in "non-volatile" memory and then
exit the programming mode.
- 5 -
Advertisement
