LEADING EDGE SAFETY TRIREX AB-O2 Instruction Manual page 32

APPENDIX C—ENGAGEMENT ARM INSTALLATION (CONT.)
E
N
READ AND UNDERSTAND THE ENTIRE SET OF INSTRUCTIONS BEFORE PERFORMING ANY STEP IN THIS PROCESS
G
L
I
S
H
STEP 7
Insert the Clevis Joint Snap-In Pins (19a)
through Yoke End Linkage (19b) and
mounting points as shown. Repeat for both
ends.
STEP 8
Cut and remove any baling wire used to compress the shock,
allowing the Engagement Arm Assembly (6) to
return to its upward resting position.
Rotate Clevis Joint Snap-In Pins (19a) to snap on to
Yoke End Linkage (19b). Repeat for both ends.
STEP 9
Position the Engagement Arm Cable (20) with the attachment
point as shown.
T R ™ I
RI EX NSTRUCTION
19a
20
M
ANUAL
19b
19a
19b
31
6
19a
19b
20