Table of Contents
Advertisement
Filter in the water supply is
blocked
Release water pressure in the supply
1.
hose:
a) Turn off the water tap.
b) Select any programme (except q
Rinse/Spin 0).
c) Touch the I button. Allow the
programme to run for approx. 40
seconds.
d) Press the # button. The
appliance is switched off.
e) Pull out the mains plug.
Clean the filters:
2.
a) Disconnect the hose from the
tap.
Clean the filter with a small brush.
b) For standard and Aqua-Secure
models, clean the filter on the
rear of the appliance:
Disconnect the hose from the
rear of the appliance.
Use pliers to remove the filter and
then clean it.
Connect the hose and check for
3.
leaks.
Faults and what to do about them
3
Faults and what to do
about them
E mergency release
F a u l t s a n d w h a t t o d o a b o u t t h e m
E.g. power outage or in the event of a
loss of power
The programme continues when the
power supply is restored.
However, if the laundry has to be
removed, the appliance door can be
opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
and laundry.
If possible, leave it to cool down first.
Caution!
Risk when reaching into/gripping the
rotating drum!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.
Caution!
Water damage!
Any escaping water may cause water
damage.
Do not open the door if water can be
seen through the glass.
Switch off the appliance. Pull out the
1.
mains plug.
Drain the water ~ Page 48
2.
Pull the emergency release
3.
downwards with a tool and release.
The door can then be opened.
en
49
Advertisement
Table of Contents
