en Troubleshooting
Fault
"E:30 / -80"
"E:36 / -25 / -26"
"E:38 / -25 / -26"
"E:10 / -00 / -10 /
-20"
58
Cause and troubleshooting
Unapproved extension installed on the water drain
hose.
Remove any unapproved extensions from the water
▶
hose. Connecting the appliance
Drain pump is blocked.
→ "Cleaning the drain pump", Page 51
▶
Drain pump is blocked.
→ "Cleaning the drum", Page 49
▶
if the fault is displayed again,
→ "Cleaning the drain pump", Page 51
▶
Inlet opening of the rubber gasket is blocked.
→ "Cleaning the intake opening in the rubber gas-
▶
ket", Page 54
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 49
If this indicator appears again, call our after-sales
3.
service.
→ "Customer Service", Page 70
Note: You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
→ "Buttons", Page 23
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
Clean the filters in the water inflow → Page 55.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
The detergent drawer has not been pushed in as far
as it can go.
Push the detergent drawer in as far as it will go.
▶
The pump unit is not inserted.
Insert the pump unit into the detergent drawer.
1.
→ "Cleaning the detergent drawer", Page 49
Push the detergent drawer in as far as it will go.
2.