APRILIA TUAREG 660 Instruction Manual page 71

6.2) Change user code (Change user code)
This function may be used to modify the existing code (you must be in possession of
the code itself in order to do this). The user code enables engine start even in the
event of an immobiliser system fault. On a new vehicle, the user code is set by default
as five zeros (00000) and the message "INSERT YOUR PERSONAL CODE" appears
on the display for ten seconds when the ignition is switched on.
This function allows you to change the code itself and remove this message.
A value (from 0 to 9) is shown for the first figure of the code (furthest to left) on the
display. Press MODE UP or MODE DOWN to modify the value. Press MODE SET
02_89
briefly to confirm the selection. Repeat the operation for all the digits. Once the code
is confirmed, the new code is shown steadily on the display to let the user verify that
the code has been entered correctly. Turn the ignition off and then on again to unlock
the dashboard. The last code set may be modified again in future. Access the setting
mode again, enter the last user code used (OLD CODE), then enter a new user code
(NEW CODE) as described previously.
GPS NAVIGATION (where applicable)
The "APRILIA MIA" system, paired with the "APRILIA" application, allows GPS indi-
cations to be shown on the digital display. By means of pictograms, distance and travel
time data, the desired destination can be reached.
Consult the navigation guide by accessing the "APRILIA" application with your ac-
count. The navigation icon appears on the digital display after setting the destination
address.
02_90
Press and hold down MODE RIGHT to access the GPS navigation directions and
information screen.
71