APRILIA TUAREG 660 Instruction Manual page 161

To carry out vertical adjustment of the light beam:
(LOW BEAM HEADLIGHTS)
•
Operating from the rear side of the fairing, under the internal bodywork, act
on the adjuster ("1" left side / "2" right side). SCREWING (clockwise) the light
beam is lowers; UNDO the screw (anticlockwise) to raise the light beam.
•
These two adjuster screws may be used to adjust the vertical alignment of
the low beam headlight beam.
NOTE
04_21
CHECK THAT THE VERTICAL ALIGNMENT OF THE BEAM IS CORRECT.
04_22
(HIGH BEAM HEADLIGHT)
From under the light using a Phillips-head screwdriver, act on the adjuster (3) at the
point indicated:
•
Turn the screwdriver clockwise to raise the beam;
•
Turn the screwdriver anticlockwise to lower the beam.
This adjuster screw may be used to adjust the vertical alignment of the high beam
headlight beam.
NOTE
04_23
CHECK THAT THE VERTICAL ALIGNMENT OF THE BEAM IS CORRECT.
161