Gravely ZT Sport Owner's/Operator's Manual page 18

SERVICING THE BATTERY
NOTE: Unit comes equipped with a
maintenance-free battery that requires no
regular maintenance except cleaning
terminals.
WARNING: Battery posts, terminals
and related accessories contain lead
and lead compounds, chemicals
known to the State of California to
cause cancer and reproductive harm.
Wash hands after handling.
1
11
10
9
8
1. Seat
2. Detent Pin
3. Operator Presence
Switch Wires
4. Seat Retainer Slot
Install
1. Install battery (item 6) on unit.
2. Install cross brace (item 7) and battery
hold down bracket (item 5).
3. Connect positive (+) cable (item 10) first,
then negative (–) cable (item 9).
4. Apply petroleum jelly or dielectric grease
to battery cable ends and terminals.
Battery Removal and Installation
(Figure 20)
Remove
NOTE: Tag and mark wires prior to
disconnecting.
1. Remove detent pin (item 2) and tip seat
2. Disconnect operator presence switch
3. Disconnect negative (–) cable (item 9)
4. Remove battery hold down bracket
5. Remove battery (item 6) from unit.
5. Battery Hold Down
Bracket
6. Battery
7. Cross Brace
8. Negative (–) Terminal
Figure 20
5. Install seat (item 1) in seat retainer slots
6. Put seat (item 1) down and install detent
Cleaning Battery and Battery Cables
(Figure 20)
1. Remove battery from unit (see Battery
GB - 18
(item 1) forward.
wires (item 3) and remove seat (item 1)
from seat retainer slots (item 4).
first then positive (+) cable (item 10).
(item 5) and cross brace (item 7).
9. Negative (–) Cable
10. Positive (+) Cable
11. Positive (+) Terminal
(item 4) and connect operator presence
switch wires (item 3).
pin (item 2).
Removal and Installation on page 18).
2
3
4
5
6
7
OE0028