Preparing A Beverage; One Capsule (E. G. Lungo) - Krups INFINISSIMA KP170 User Manual

6.

PREPARING A BEVERAGE

6. 1 ONE CAPSULE (E. G. LUNGO)

1
Check if the water tank contains enough fresh drinking
water. Switch on machine. Power button starts blinking red
while machine is heating up for approximately 40 seconds.
Afterwards power button lights steady green. Machine is
ready to be used.
4
Push selection lever to the "HOT" or "COLD" position as
recommended on capsule packs. Beverage preparation
starts.
7
After extraction is finished open locking handle. Remove cup
from drip tray.
2
To adjust drip tray position: Turn drip tray counter
clockwise to unlock it. Lift it to the desired position and
lock it by turning it clockwise until it clicks. The drip tray is
locked.
5
STOP
Stay beside the machine throughout the preparation!After
reaching the desired level push selection lever to the
"STOP" position. Machine stops preparation.
8
Pull out capsule holder. Remove used capsule. Put used
capsule in dustbin.
10
3
Place cup with correct cup size on drip tray. See
"BEVERAGE EXAMPLES" or package. Open locking handle.
Pull out capsule holder. Make sure rinsing tool is not
inside. Insert capsule in capsule holder. Insert it back into
machine. Close locking handle.
6
After finishing preparation the power button blinks red for
about 5 seconds. During that time do not open locking
handle!
9
Rinse capsule holder with fresh drinking water from both
sides. Dry capsule holder. Insert it back into machine.
Enjoy your beverage!