Front Panel Support And Power Connectors - Supermicro X10DRS-2U User Manual

Front Panel Support and Power Connectors

An SMCI-proprietary front panel is used to provide front I/O support and power
connections for your system. Refer to the layout below for locations of the I/O front
panel and the 4-pin power connector. For more information on the I/O front panel or
back panel used in your system, please refer to our website at www.supermicro.com.
Front Panel Support and Power Connectors
X10DRS
REV:1.03
BIOS
LICENSE
BAR CODE MAC CODE
11
SAS CODE
Front Panel Support & Power Connectors
1. M1
3. M3
5. PM1 (Power Connector 1)
7. M5
9. M7
11. 4-pin PWR (on the motherboard)
Note: An SMCI-proprietary backplane is required for your front-panel sup-
port. Please install the required component on the front of your chassis
to ensure proper front-panel setup. Please refer to our website at www.
supermicro.com for more product info.
9 8
10
2-21
Chapter 2: Installation
7 6 5
2. M2
4. Guide Pin
6. M4
8. M6
10. PM2 (Power Connector 2)
4 3 2 1