Advertisement
3 ß
– :
The shaver head is fixed for full control
and precise handling in hard to reach
areas.
Long hair trimmer
To trim sideburns, moustache or beard,
slide the long hair trimmer (4) upwards.
Tips for the perfect dry shave
For best shaving results, Braun recom-
mends you to follow 3 simple steps:
1. Always shave before washing your
face.
2. At all times, hold the shaver at right
angles (90°) to your skin.
3. Stretch your skin and shave against
the direction of your beard growth.
Cleaning
Regular cleaning ensures better shaving
performance. Rinsing the shaver head
under running water after each shave is
an easy and fast way to keep it clean:
• Press the foil release buttons (3) to lift the
shaver foil. Do not remove the shaver
foil completely.
• Switch the shaver on (cordless) and
rinse the shaver head under hot running
water until all residues have been
removed. You may use liquid soap
without abrasive substances. Rinse off
all foam and let the shaver run for a few
more seconds.
• Next, switch off the shaver and remove
the shaver foil (1). Then leave the
disassembled shaving parts to dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil onto the long hair
trimmer and shaver foil.
The following quick cleaning is another
alternative cleaning method:
20
• Press the foil release buttons (3) to lift
the shaver foil (do not remove the foil
completely). Switch on the shaver for
approx. 5–10 seconds so that the shaved
stubbles can fall out.
• Switch off the shaver. Remove the
shaver foil and tap it out on a flat
surface. Using a brush, clean the inner
area of the shaver head. However, do
not clean the shaver foil nor the cutter
block with the brush as this will damage
them.
Keeping your shaver in top
shape
Replacing the shaver foil and cutter
block / reset
To maintain 100% shaving performance,
replace the shaver foil (1) and cutter block
(2), when the replacement symbol (9)
lights up after about 18 months or when
worn.
The replacement symbol will remind you
during the next 7 shaves to replace the
shaving parts. Then the shaver will
automatically reset the display.
After you have replaced the shaving parts
(foil and cutter block), press the on/off
switch (6) for at least 5 seconds to reset
the counter.
While doing so, the replacement light
blinks and goes off when the reset is
complete.
The manual reset can be done at any
time.
Accessories
Available at your dealer or Braun Service
Centres:
Shaver foil and cutter block: 51B
Advertisement
