Advertisement
Available languages
Available languages
SUMMARY
FLEXILIGHT LED is a new serie of product for a professional design.
You can decorate both indoors and outdoors from the buildings, highlighting
something, surroundings from a specified place, making a kind of symbol or
lighting windows, entrances, stairs, trailers, cars, etc. It all depends on the ima-
gination of each one.
WARNING: Avoid making inappropriate installations as well these ones which
are damaged, and please, we invite you to read carefully the following ins-
tructions manual to do a safe installation.
The product is supplied with power cable and end cap. The rest of accessories
are sold separately, for instance, heat shrink tubes, flanges, cable conduit, etc
1
CONNECTION WITH THE SIMPLE CONNECTOR BETWEEN
FLEXILIGHT
1. Cut a 7cm section from the heat shrink tube, at least, and place it in one
of the thread.
2. Enter the pins of the simple connector inside the cable of the luminous
thread.
shrink tube
HOW TO CONNECT THE POWER CABLE
1. Make sure that the luminous thread, which is going to be manipulated, is
not connected to any power supplier.
2. Enter the connector with the pin male in the luminous thread in its right
position.
3. Place the heat shrink tube over the luminous thread.
shrink tube
INSTRUCTIONS FOR ITS USE.
THE CUT OF THE LUMINOUS THREAD
1. Cut only the cable along the crops marks indicated.
2. To avoid possible short-circuits, make sure that the cut of the cables has
been done cleanly- Bend the luminous thread from the left to the right and,
after that, cut the copper cable which edges.
3.
seal it with silicone, tie it with a flange (no included) for its totally insulation.
The other extreme of the luminous thread can be linked by a power cable
(included), which has been also sealed to get the perfect tightness.
2
3. Centre the heat shrink tube with the simple connector and apply heat
until it remains completely sealed.
simple connector
4. Enter the other luminous thread in the connector, Make sure that the
connector has fixed in the right position inside the luminous thread.
5. Once both of there are right fixed, apply some heat if you had used a
shrink tube with silicone.
6. The connectors and the joints cope with a limit of pressure.
plug
Cover the end of the luminous thread with a end cap which is included,
3
End cap
Advertisement
