DeWalt EV CHARGER DXPAEV048 Instruction Manual page 8

3. Loosen the connector screws on the terminal blocks.
4. Fully insert the wires into the connectors on the terminal
blocks accordingly:
• Green wire - PE pin
• Red wire - L2 pin
• Black wire - L1 pin
5. Tighten each connector screw to clamp the crimped terminals
securely in place, with a torque of 13.3 in·lbs to 17.7 in·lbs
(1.5 N·m to 2 N·m).
6. Tighten the cable gland with a torque of 53 in·lbs to 71 in·lbs
(6 N·m to 8 N·m).
NOTICE: The cable gland entry is recommended for 0�9 – 1�3"
(24 - 32 mm) cables, therefore a 1" conduit fitting is recommended�
7. Close the cover plate and fasten the 4 screws with a torque of
4.4 in·lbs to 8.9 in·lbs (0.5 N·m to 1 N·m).
FIXING THE MAIN UNIT TO THE WALL BRACKET
1. Hang the main unit from the top of the wall bracket.
2. Fasten the bolt at the bottom of the main unit using the T25
Operating Instructions
Display
Charging Status
READY
PE
L1
CHARGING
L2
CHARGING
COMPLETE
RESET SUCCESS Network information and local data has been
UPGRADING
Automatic Charging
• With the product powered, it starts charging few seconds after
connecting the charging handle to the vehicle's charging port.
• The product automatically detects outlet voltage and maximum
allowable input current of your vehicle.
1. Press the release lever and take the charging handle off the
2. Plug the SAE-J1772 connector of the charging handle to the
3. The product switches off automatically once the vehicle's
NOTICE: When the charging is complete, press the release lever and
unplug the SAE-J1772 connector� Place the charging handle back
into the handle cradle of the main unit�
Registering and Connecting the Charger
Scan the code below to download the D
to control the charging sessions, monitor the charging status in real-
CABLE GLAND
time and set charging schedules.
8
torx L-key (recommended torque 5.0 to 5.8 N·m).
Description
Standby status. Power is connected to the
product.
Charging is in progress.
The charging process is complete or in
scheduled charging mode.
cleared.
Firmware upgrade is in progress.
handle cradle.
vehicle's charging port. The charging process starts.
battery is fully charged.
WALT EV Charger app
E