DeWalt EV CHARGER DXPAEV048 Instruction Manual page 5

WARNING - Grounding Instructions for
Permanently Connected Product
This product must be connected to a grounded, metal, permanent
wiring system or an equipment-grounding conductor must be
run with the circuit conductors and connected to the equipment
grounding terminal or lead on the product�
The lightning flash with arrowhead within a triangle is
intended to tell the user that parts inside the product
are a risk of shock to persons.
SAVE THESE
INSTRUCTIONS
Before First Use
DANGER: Risk of suffocation! Keep any packaging materials
away from children and pets - these materials are a potential source
of danger, e�g� suffocation�
• Remove all packaging materials
• Remove and review all components before use�
• Check the product for transport damages�
Main Unit Components
A. Main Unit
B. Display
C. Handle Cradle
D. Release Lever
G
Wall Mounting Hardware
H. Screws (x4)
I. Wall Anchors (x4)
H I
E. Charging Handle
F. Protective Cover
G. Wall Bracket
A
J. Bolt (x1)
K. T25 Torx L-Key (x1)
J K
Display
L. Output Current
M. Charging Status
N. Wi-Fi Status
O. Charging Time
L
R
Installation Instructions
WARNING: Wear proper personal protection equipment when
installing the product�
CAUTION: Protect the product from harsh weather conditions
such as rain, snow and extreme temperatures� Consider installing the
product under a carport or in a garage�
CAUTION: Install the product in a safe location away from
flammable materials and out of reach of children and pets�
CAUTION: Take care not to drill into any pipes or power lines
beneath the surface during mounting holes preparation� Use a power
line/ metal detector�
NOTICE: It is recommended to install the product at a sufficient
height from grade such that the height of the storage means for the
coupling device is located between 24" (600 mm) and 48" (1�2 m)
from grade�
B
• Install the product within convenient proximity to where the
hardwired circuit will be installed by a licensed electrician.
Additionally, ensure that the cord or wiring leading into the
product has some slack.
C
• For optimal charging efficiency, place the product as close as
possible to the electrical panel to avoid lengthy cable runs.
D
• Install the product to an easily accessible location for the driver
to plug in and out the vehicle. Make sure the installation location
E allows enough slack for the charging cable to reach the vehicle's
charging port.
F
• Test the Wi-Fi signal quality at the installation location.
• The wall used for installation must have the capacity to support
the weight of the product and its accessories and must remain
level once the installation is completed.
• Avoid installing the product in areas with excessive vibration or
elevated temperatures.
5
P. Actual Current
Q. Electricity Consumption
R. Voltage
M N
Q P O