Table of Contents
Advertisement
CLEANING
Preventive maintenance for your Holman Oven consists of the following recommended cleaning
procedures. To keep your oven in its top operating condition, these steps should be performed on a
daily, weekly or as indicated.
DISCONNECT UNIT FROM POWER SUPPLY OR TURN POWER OFF AT WALL
BREAKER.
WARNING
DAILY
1. Turn main power switch to the OFF position. Disconnect unit from power source and
allow to cool.
2. Using a mild detergent, wipe exterior surfaces, clean with a damp cloth.
a. For lightly soiled build-up, clean with a damp cloth.
b. For heavily soiled build-up, use an soft damp cloth and mild detergent.
DO NOT use caustic cleaners.
3. Remove the load & unload tray by lifting them out of position. Clean using mild detergent and
warm water.
4. Remove each crumb tray by sliding each of them out from under the conveyor belt.
Clean crumb trays by wiping with a damp cloth and mild detergent.
DO NOT use caustic cleaners. Place trays back in place prior to putting unit back into
operation.
CAUTION
5. Reconnect power.
WEEKLY
1. Turn main Power switch to the OFF
position. Disconnect unit from power
source and allow to cool.
2. Perform daily cleaning procedures.
3. Using a damp cloth, wipe clean the fan
guard located on the control box cover
under the unit.
CLEAN CONVEYOR BELT
4. Reconnect power or turn power back on.
5. Switch the ON/OFF switch to the ON
position, and turn Conveyor to its fastest
setting.
6. With the Conveyor turned on and the crumb trays in place, take a wire grill brush or dry abrasive
pad, clean the exposed surface of Conveyor Belt by passing the brush or pad, back and forth
across the surface of the Conveyor Belt as the belt moves past. Continue until the entire belt is
clean. Make sure the Crumb Tray is installed, this will minimize the amount of particles that fall
into the oven.
7. When the Conveyor Belt is clean, take a damp cloth and wipe the conveyor, removing
any loose particles on the belt surface. Turn Conveyor OFF.
8. Remove the Crumb Trays by sliding out from beneath the conveyor belt. Clean the
Crumb Trays by wiping with a damp cloth and mild detergent.
DO NOT use caustic cleaners.
DO NOT RUN CONVEYOR OVEN WITHOUT CRUMB TRAYS INSTALLED.
DO NOT IMMERSE OR LET THE UNIT STAND IN WATER.
DO NOT HOSE DOWN THE UNIT OR THE TABLE/COUNTER IF THE UNIT IS ON THE
TABLE/COUNTER.
WARNING
KEEP AWAY FROM RUNNING WATER.
CLEANING CONVEYOR BELT
IL1023
Advertisement
Table of Contents
