Section 6: Heater Installation - Roberts Gorden Vantage HE-40 Installation, Operation & Service Manual

Gas-fired, low intensity unitary heater designed for harsh environments
Hide thumbs Also See for Vantage HE-40:
Table of Contents

Advertisement

SECTION 6: HEATER INSTALLATION

WARNING
Severe Injury Hazard
Secure burner to burner tube with bolts and
lockwashers.
Hang heater with materials with a minimum
working load of 75 lbs (33 kg).
Failure to follow these instructions can result
in death, injury or property damage.
WARNING
Cut/Pinch Hazard
Wear protective gear during installation,
operation and service.
Edges are sharp.
Failure to follow these instructions can result
in injury.
To ensure your safety, and comply with the terms of
the warranty, all units must be installed in accor-
dance with these instructions.
The gas or the electrical supply lines must not be
used to support the heater.
Do not locate the gas or electric supply lines directly
over the path of the flue products from the heater.
The heater must be installed in a location that is
readily accessible for servicing.
The heaters must be installed in accordance with
clearances to combustibles as indicated on the rating
plate and in this instruction manual.
The minimum and maximum gas inlet pressures
must be maintained as indicated on the rating plate.
Typical installation configurations are shown in
Figure 14.
Expansion and contraction of the tube dictates that
the minimum suspension lengths in the table on
Page 16, Figure 14 be maintained.
SECTION 6: H
I
EATER
NSTALLATION
15

Advertisement

Table of Contents
loading

Table of Contents